State University of Medical and Applied Sciences, Igbo-Eno Cut Off Mark for Metallurgical and Materials Engineering

The cut-off mark for Metallurgical and Materials Engineering at the State University of Medical and Applied Sciences (SUMA), Igbo-Eno, is a key admission requirement for UTME candidates. Historically, Nigerian universities set cut-off marks within the 180–220 range, but the exact current-year figure for this programme is determined by SUMA and JAMB. Prospective students should verify the official score from the university and JAMB portals before applying.

Quick Facts

• Duration: 5 Years (UTME) / 4 Years (Direct Entry)
• Typical UTME Subjects: English Language, Mathematics, Physics, Chemistry
• Typical O’Level Requirements: 5 O’Level credits including English Language, Mathematics, Physics and Chemistry
• Historical Cut-Off Range: 180 – 220 (general range across Nigerian universities, not this university’s exact current figure — always confirm with JAMB or the university’s admissions office).

Frequently Asked Questions

• How is the cut-off mark for Metallurgical and Materials Engineering at SUMA Igbo-Eno determined?
  The cut-off mark is set by SUMA’s admission committee based on factors such as the number of applicants, available slots, and the overall performance of candidates in the UTME. It is subject to change each year.
• Where can I check the official current-year cut-off mark for this course?
  The official cut-off mark is published on the SUMA Igbo-Eno website and the JAMB portal (e.g., JAMB CAPS). Always refer to these sources for the most accurate and up-to-date figure.
• What happens if I score below the cut-off mark for Metallurgical and Materials Engineering?
  If your score is below the cut-off, you may not be considered for admission into that programme. You can either apply for a change of course to a less competitive programme within SUMA, or consider other universities with lower cut-off marks.

Stay updated by regularly visiting the official JAMB and SUMA Igbo-Eno websites for the exact cut-off mark for Metallurgical and Materials Engineering this academic session. Meeting or exceeding the required score is only one step—ensure you also satisfy all O’Level and post-UTME requirements. Good luck with your application!