Obong University, Obong Ntak Cut Off Mark for Mechatronics Engineering

Obong University, Obong Ntak offers a 5-year (UTME) or 4-year (Direct Entry) Mechatronics Engineering programme. The institution’s cut‑off mark for this course is typically within the general JAMB range of 200–230, but the exact figure for the current admission year must be confirmed from official sources.

Quick Facts

• Duration: 5 Years (UTME) / 4 Years (Direct Entry)
• Typical UTME Subjects: English Language, Mathematics, Physics, Chemistry
• Typical O’Level Requirements: 5 O’Level credits including English Language, Mathematics, Physics and Chemistry
• Historical Cut-Off Range: 200 – 230 (general range across Nigerian universities, not this university’s exact current figure — always confirm with JAMB or the university’s admissions office).

Frequently Asked Questions

• How is the cut-off mark for Mechatronics Engineering at Obong University determined?
  The cut-off mark is set each year by the university’s Senate in line with JAMB’s national minimum score and the number of applicants. It may also depend on the performance of candidates in the post-UTME screening.
• Where can I check the official current-year cut-off mark for Mechatronics Engineering at Obong University?
  The official cut-off mark is published on the Obong University admission portal and the JAMB e‑facility website. Candidates should check these platforms after the release of UTME results.
• What happens if a candidate scores below the cut-off mark for Mechatronics Engineering?
  Candidates below the cut-off may not be considered for admission into Mechatronics Engineering. They can opt for a change of course or institution via JAMB, or wait for supplementary lists if the university offers a lower threshold for other programmes.

Always verify the exact cut‑off mark for Mechatronics Engineering at Obong University from the official JAMB portal or the university’s admissions website. Admission requirements and scores are updated annually, so relying on current, official data is essential for a successful application.