Kola Daisi University Ibadan Cut Off Mark for Mechanical Engineering

The cut-off mark for Mechanical Engineering at Kola Daisi University, Ibadan, is determined annually by the Joint Admissions and Matriculation Board (JAMB) and the university. While general cut-off ranges across Nigerian universities have historically been between 220 and 250, the exact figure for this programme is set by the institution each year. Prospective candidates should always verify the current year’s cut-off from official sources before applying.

Quick Facts

• Duration: 5 Years (UTME) / 4 Years (Direct Entry)
• Typical UTME Subjects: English Language, Mathematics, Physics, Chemistry
• Typical O’Level Requirements: 5 O’Level credits including English Language, Mathematics, Physics and Chemistry
• Historical Cut-Off Range: 220 – 250 (general range across Nigerian universities, not this university’s exact current figure — always confirm with JAMB or the university’s admissions office).

Frequently Asked Questions

• How is the cut-off mark for Mechanical Engineering at Kola Daisi University determined?
  The cut-off mark is set by the university in collaboration with JAMB, based on factors like the number of applicants, the performance of candidates in UTME, and the university’s admission capacity. It is usually announced after the UTME results are released.
• Where can I check the official current-year cut-off mark for this programme?
  The official cut-off mark is published on the JAMB eFacility portal (jamb.gov.ng) and the Kola Daisi University, Ibadan admissions website. Always rely on these sources for the most accurate figure.
• What happens if I score below the cut-off mark for Mechanical Engineering?
  If your UTME score is below the cut-off, you may not be eligible for admission into Mechanical Engineering for that session. You could consider other programmes at the university with a lower cut-off, or apply for a change of course/institution through JAMB.

To ensure you have the most accurate and current information, always visit the official JAMB portal and the Kola Daisi University, Ibadan admissions page. The exact cut-off mark for Mechanical Engineering changes yearly, so confirm it before making any admission decisions. Good luck with your application!