Kebbi State University of Science and Technology Cut Off Mark for Metallurgical and Materials Engineering

The cut-off mark for Metallurgical and Materials Engineering at Kebbi State University of Science and Technology (KSUST) is determined annually by the university in collaboration with JAMB. While general cut-off marks across Nigerian universities often fall within the 180–220 range, the exact figure for this programme is set each admission year. Candidates should note that the official current-year cut-off mark is not fixed and must be confirmed from authoritative sources.

Quick Facts

• Duration: 5 Years (UTME) / 4 Years (Direct Entry)
• Typical UTME Subjects: English Language, Mathematics, Physics, Chemistry
• Typical O’Level Requirements: 5 O’Level credits including English Language, Mathematics, Physics and Chemistry
• Historical Cut-Off Range: 180 – 220 (general range across Nigerian universities, not this university’s exact current figure — always confirm with JAMB or the university’s admissions office).

Frequently Asked Questions

• How is the cut-off mark for Metallurgical and Materials Engineering at KSUST determined?
  The cut-off mark is set based on factors such as the number of applicants, the university’s admission capacity, and the overall performance of candidates in the UTME. KSUST also considers its own departmental benchmark after JAMB releases the national minimum cut-off.
• Where can I check the official current-year cut-off mark for this course?
  The official cut-off mark is published on the university’s website (ksusta.edu.ng) and the JAMB e-facility portal. Always verify directly from these sources as third-party sites may not have the most up-to-date figure.
• What happens if I score below the cut-off mark for Metallurgical and Materials Engineering?
  Candidates who score below the cut-off may not be considered for admission to this programme. However, they can opt for a change of course or institution through JAMB’s change of course/institution portal, or consider other available programmes with lower cut-offs at KSUST.

Since cut-off marks change each admission cycle, it is essential to check the latest information directly from the JAMB official website and the KSUST admissions portal. Do not rely on unverified numbers from past years. Stay updated and ensure your UTME score meets the current requirement for Metallurgical and Materials Engineering at Kebbi State University of Science and Technology.