First Technical University Ibadan Cut Off Mark for Metallurgical and Materials Engineering

First Technical University Ibadan (Tech-U) sets its departmental cut-off mark for Metallurgical and Materials Engineering based on JAMB’s annual minimum and the programme’s competitiveness. Historically, cut-off marks across Nigerian universities fall between 180 and 220, but the exact figure for this course varies each admission year. Prospective candidates must meet the university’s specific score to be considered for admission.

Quick Facts

• Duration: 5 Years (UTME) / 4 Years (Direct Entry)
• Typical UTME Subjects: English Language, Mathematics, Physics, Chemistry
• Typical O’Level Requirements: 5 O’Level credits including English Language, Mathematics, Physics and Chemistry
• Historical Cut-Off Range: 180 – 220 (general range across Nigerian universities, not this university’s exact current figure — always confirm with JAMB or the university’s admissions office).

Frequently Asked Questions

• How is the cut-off mark for Metallurgical and Materials Engineering at First Technical University Ibadan determined?
  The cut-off mark is set by the university’s admission committee after considering the JAMB-approved minimum, the number of applicants, the performance of candidates in the UTME, and the available slots for the programme. It is not fixed and may change yearly.
• Where can I check the official current-year cut-off mark for this course?
  The official cut-off mark is published on the First Technical University Ibadan admissions portal and the JAMB CAPS system. You should visit the university’s website or the JAMB e-facility for the most recent and accurate figure.
• What happens if my UTME score is below the cut-off mark for Metallurgical and Materials Engineering?
  Candidates who score below the cut-off may not be offered admission into this programme. However, they can consider changing their course to a less competitive one at the same university or apply for other institutions through JAMB change of institution.

To confirm the exact current-year cut-off mark for Metallurgical and Materials Engineering at First Technical University Ibadan, always refer to the official JAMB and university portals. For the most reliable information, check the admission list and departmental requirements as released by the university. Good luck with your application!