Abdulrasaq Abubakar Toyin University Cut Off Mark for Industrial Engineering

The cut-off mark for Abdulrasaq Abubakar Toyin University (AATU) Industrial Engineering is determined by the university in conjunction with JAMB each year. Candidates must meet the general entry requirements, including five O’Level credits in English, Mathematics, Physics, and Chemistry, and score the prescribed UTME aggregate.

Quick Facts

• Duration: 5 Years (UTME) / 4 Years (Direct Entry)
• Typical UTME Subjects: English Language, Mathematics, Physics, Chemistry
• Typical O’Level Requirements: 5 O’Level credits including English Language, Mathematics, Physics and Chemistry
• Historical Cut-Off Range: 180 – 220 (general range across Nigerian universities, not this university’s exact current figure — always confirm with JAMB or the university’s admissions office).

Frequently Asked Questions

• How is the cut-off mark for Industrial Engineering at AATU determined?
  The cut-off is set by the university’s admissions committee based on factors such as the number of applicants, JAMB’s national minimum, and the programme’s capacity. It is usually within the general historical range of 180–220, but the exact figure is announced annually.
• Where can I check the official current-year cut-off mark for Industrial Engineering?
  The official cut-off mark is released on the JAMB CAPS portal and the Abdulrasaq Abubakar Toyin University website. Always verify from these sources rather than relying on third-party information.
• What happens if my UTME score is below the cut-off mark for Industrial Engineering?
  You may still be considered for a change of course to a less competitive programme within the university, or you can apply for admission through Direct Entry if you meet the requirements. Alternatively, you can retake the UTME in the next session.

Always confirm the exact current-year cut-off mark for Industrial Engineering by visiting the official JAMB CAPS portal and the Abdulrasaq Abubakar Toyin University admissions page. Meeting the cut-off is only one part of the admission process; ensure you also satisfy all O’Level and post-UTME requirements.