Federal University, Dutsin-Ma Cut Off Mark for Metallurgical and Materials Engineering

The cut-off mark for Metallurgical and Materials Engineering at Federal University, Dutsin-Ma (FUDMA) is the minimum UTME score required to be considered for admission into this five-year programme. While general historical cut-off marks for Nigerian universities range from 180 to 220, the exact current-year figure for FUDMA is set by the university and the Joint Admissions and Matriculation Board (JAMB). Candidates are advised to rely solely on the official university or JAMB portal for the precise value.

Quick Facts

• Duration: 5 Years (UTME) / 4 Years (Direct Entry)
• Typical UTME Subjects: English Language, Mathematics, Physics, Chemistry
• Typical O’Level Requirements: 5 O’Level credits including English Language, Mathematics, Physics and Chemistry
• Historical Cut-Off Range: 180 – 220 (general range across Nigerian universities, not this university’s exact current figure — always confirm with JAMB or the university’s admissions office).

Frequently Asked Questions

• How is the cut-off mark for Metallurgical and Materials Engineering at FUDMA determined?
  The cut-off mark is determined by JAMB’s national policy in conjunction with the university’s own admission committee. It takes into account factors such as the number of applicants, the performance of candidates in UTME, and the available admission slots for the department.
• Where can I check the official current-year cut-off mark for this course?
  The official cut-off mark is published on the FUDMA admissions portal (www.fudutsinma.edu.ng) and on JAMB’s Central Admissions Processing System (CAPS). Check these sources after each UTME registration cycle.
• What happens if my UTME score is below the cut-off mark for Metallurgical and Materials Engineering?
  If your score is below the cut-off, you will not be considered for admission into that specific programme. You may still be eligible for other courses with lower cut-off marks within FUDMA, or you can change institution or apply for a JAMB change of course.

The exact cut-off mark for Metallurgical and Materials Engineering at Federal University, Dutsin-Ma changes annually based on admission statistics. Visit the official JAMB CAPS portal or the FUDMA website for the current year’s figure. Ensure you meet all O’Level requirements and other admission criteria before applying.