First Technical University Ibadan Cut Off Mark for Mechatronics Engineering

The cut-off mark for Mechatronics Engineering at First Technical University Ibadan is the minimum UTME score required to be considered for admission into the programme. While the exact figure changes each year, the general historical cut-off range for competitive engineering courses in Nigeria is between 200 and 230. Candidates must also meet the O’Level requirements of five credits including English Language, Mathematics, Physics, and Chemistry.

Quick Facts

• Duration: 5 Years (UTME) / 4 Years (Direct Entry)
• Typical UTME Subjects: English Language, Mathematics, Physics, Chemistry
• Typical O’Level Requirements: 5 O’Level credits including English Language, Mathematics, Physics and Chemistry
• Historical Cut-Off Range: 200 – 230 (general range across Nigerian universities, not this university’s exact current figure — always confirm with JAMB or the university’s admissions office).

Frequently Asked Questions

• How is the cut-off mark for Mechatronics Engineering determined?
  The cut-off mark is set annually by the university’s admissions committee based on factors like the number of applicants, the programme’s capacity, and the overall performance of candidates in that year’s UTME. It may also align with JAMB’s national minimum cut-off.
• Where can I check the official current-year cut-off mark for this course?
  The official cut-off mark for the current admission year is published on the First Technical University Ibadan website (e.g., under ‘Admissions’ or ‘Programme Requirements’) and also on the JAMB CAPS portal. Always refer to these sources for the most accurate figure.
• What happens if I score below the cut-off mark?
  If your UTME score is below the cut-off, you may not be offered admission into Mechatronics Engineering. However, you could consider other programmes with lower cut-offs at the same university, apply for a change of course through JAMB, or retake the UTME in the next cycle.

Knowing the exact cut-off mark for Mechatronics Engineering at First Technical University Ibadan is crucial for your admission planning. Because the figure changes each year, always confirm the current value from the official JAMB website and the university’s admission portal. Stay updated to make informed decisions about your application.