Lighthouse University, Evbobanosa Cut Off Mark for Metallurgical and Materials Engineering

The cut-off mark for Metallurgical and Materials Engineering at Lighthouse University, Evbobanosa, is an important admission requirement for UTME candidates. While general cut-off marks for Nigerian universities have historically ranged between 180 and 220, the exact figure for this programme is determined annually by the university and JAMB. Candidates must meet both the cut-off mark and the specific O’Level and subject requirements to be considered for admission.

Quick Facts

• Duration: 5 Years (UTME) / 4 Years (Direct Entry)
• Typical UTME Subjects: English Language, Mathematics, Physics, Chemistry
• Typical O’Level Requirements: 5 O’Level credits including English Language, Mathematics, Physics and Chemistry
• Historical Cut-Off Range: 180 – 220 (general range across Nigerian universities, not this university’s exact current figure — always confirm with JAMB or the university’s admissions office).

Frequently Asked Questions

• How is the cut-off mark for Metallurgical and Materials Engineering at Lighthouse University determined?
  The cut-off mark is set by the university in consultation with JAMB, based on factors such as the number of applicants, the programme’s capacity, and the overall performance of candidates in that year’s UTME. It may vary from year to year.
• Where can I check the official current-year cut-off mark for this programme?
  The official cut-off mark is published on the JAMB CAPS portal and the Lighthouse University, Evbobanosa website. Candidates should monitor both platforms and the university’s admission bulletin for the latest figure.
• What happens if I score below the cut-off mark for Metallurgical and Materials Engineering?
  If your UTME score is below the cut-off mark, you will not be eligible for admission into this programme. You may consider changing your course to one with a lower cut-off or reapplying in a subsequent year after improving your score.

To proceed with your application, always verify the official cut-off mark for Metallurgical and Materials Engineering from JAMB and Lighthouse University’s admission portal. The exact figure is released each admission cycle and is the only authoritative source. Stay updated by checking the university’s website and JAMB CAPS for the most current information.